den
New Member
Posts: 16
|
Post by den on Oct 19, 2019 13:31:05 GMT -5
I was cutting down a workpiece using 1/2 spoiler board bit and the spindle stopped working all of a sudden. I cannot get it to start up again?
|
|
|
Post by gerry on Oct 19, 2019 13:46:53 GMT -5
Check fuses. Maybe overload.
|
|
|
Post by Axiom Tool Group on Oct 24, 2019 10:34:05 GMT -5
When spindle errors like this occur, error codes will shown on the VFD (RPM control) display.
Things like over load, voltage changes or temperature etc can cause the motor to stop.
If you find an error code, just give service a call. 844-642-4902
|
|